Nathaniel Picard-Busky
  • Home
  • Media
    • Photos >
      • My Guitars
      • Shows
    • Videos
    • Music
  • Improv Lessons
  • Technical Projects
  • Contact

Electronics Technology II: Digital Final Project Week 7

4/15/2015

0 Comments

 
Using what I have learned in this week’s lab, I was able to finish my Arduino code and began testing it with simple jumper wires to emulate my switches and buttons before I mock up the project with the parts that I will eventually mount to my guitar. Attached is my code. Below is a picture of one of each of my parts.

Picture
In order, a pushbutton, switch, and red and green LEDs. The LEDs are slightly different than those that I had initially found online and will require external load resistors so that they do not burn out. To allow easy mounting of this slightly additional circuitry, I will mount everything to perfboard and purchase a mounting block for my Teensy so that I can mount it on the board and house it in the guitar to keep everything streamlined. To allow for this, I will also purchase a panel mount USB port to mount near the 1⁄4” output jack of my guitar so that I can run a longer USB tether to my computer without it being snaked from the inside of the guitar. Pictoral representation of the user interface. The guitar is the guitar I will be using: 
Picture
0 Comments



Leave a Reply.

    Archives

    May 2017
    May 2015
    April 2015
    March 2015
    February 2015
    May 2014
    April 2014
    March 2014
    February 2014

    Categories

    All
    --> Built In Looper
    --> Onboard Light-Controlled Analog Guitar Effects
    --> Small-Format Multi-Effects Pedal

    RSS Feed

  • Home
  • Media
    • Photos >
      • My Guitars
      • Shows
    • Videos
    • Music
  • Improv Lessons
  • Technical Projects
  • Contact